There Are many different styles of oil candle, but they all work pretty much the same way. Below is a copy of our standard instructions, which also includes assembly instructions for the different designs if required. In the near future, we will be making the instructions available to download and print off to give to your staff so they always get it right. Right now though, you can watch videos on how to set the wick, how to fill the candles and how to light the candles Initial Set up Lamp Components Step One: Wick Adjustment Before assembling the candle, the wick must be set correctly Adjust the wick (a) so that the amount of wick showing above the wick holder (A1), is equal to the thickness of a one pence piece. Step Two: Fill Lamp Fill fuel cell (c) with fuel following the seperate filling instructions, to within a few millimetres of the top. Step Two: Assemble Lamp Insert wick structure (a) into fuel cell (b), ensuring that the longer thinner section, marked in the diagram as (d) goes inside the fuel cell. MAINTENANCE: It is advisable to adjust the wick and trim the top 1/2cm every 75 Burning hours Lighting the lamp Once the candle has been assembled correctly, allow ten minutes for the oil to soak up before for the first time. Once lit, the flame will take a couple of minutes to achieve its final height, as illustrated in the sequence of pictures below. If the flame is too large, and produces smoke, you have the wick set incorrectly. Blow out the candle, and allow ten minutes for it to cool down, then return to the beginning of the inctruction sheet and re set the wick at the correct 2mm height. Re-Filling Instructions Remove fuel cell from the shade, and then remove wick structure from the fuel cell. Refill lamp as per filling instructions. Assembly/Special Instruction: Stockholm/Oslo Insert wick structure (A) into fuel vell (C), ensuring that the longer thinner section, marked in the diagram as (d) goes inside the fuel cell. Holding the neck of the fuel cell between the thumb and forefinger, gently place fuel cell and wick (A + C) into top of shade (B) Marrakech/Amsterdam/Atlas To ensure that the fuel cell is stable and sits evenly, the bottom of the shade must be filled with a thin layer of sand to the level shown in the diagram. CIL2 Intra Lamp To achieve the Anti Spill qualities of this lamp, it is important that you only fill the candle to a height of 1 or 2cms of fuel.